Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole table

Status
Not open for further replies.
There is something different about that particular hole. Examine the exact details of how that hole was created very carefully. SW isn't lying to you. It's just telling you what it sees.
 
Thank you for the advice. I was using direct editing to offset the wall of the hole and there was the problem.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top