Hole Tables, swx 2010, sp 0.0

[generalpatton]

Got a problem with a hole table that is linked to a flat view. The label corresponds to a .187 hole, but the hole annotation lists .204. The hole size shows .187 when selecting the edge and with measuring tool.

I've tried deleting and adding them, but it still comes back as .204.

Any ideas? thanks!

 

[ctopher]

I have not seen that before. Are you using the Hole Wizard? If so, check the data there.

Chris
SolidWorks 10 SP5.0
ctopher's home
SolidWorks Legion

 

[generalpatton]

Hey, thanks. Yes, hole wizard and everything checks out OK. I've used and re-used this part/print on several occasions and haven't seen the issue before.

We were ram-rodded into a 2006 -> 2010 sp 0.0 conversion. There have been quite a few anomalies since then.

 

[ctopher]

Try updating to SP5.0.

Chris
SolidWorks 10 SP5.0
ctopher's home
SolidWorks Legion

 

[generalpatton]

That would be the proper thing to do except the uppers axed the subscription at sp 0.0.

Our former VAR did stop by the other day and offer to ship us a copy of sp 4.0.