Hole Wizard automatically "Fixes" location of first Point

[williedawg]

SW2006 & SW2010 on different computers...

It seems the HoleWizard wants to place the first hole and make it Fixed...the question is "why?"

I know I've run across this before and was able to change something to stop it from doing that, but I can't seem to find where the heck the mode is changed.

 

[CorBlimeyLimey]

You probably have the Snap to Grid option enabled.

 

[williedawg]

Checked the Snap To options and Grid wasn't checked on.
Checked the Major Grid spacing, then took out the Minor spacings...still no change.

Shut off all Snap-To options, and the HW still Fixes the first point.

Seem like it was something that was not so intuitive....and I really can't recall for sure if it was even in the Tools>Options settings

Another pic with Grid On, but no Snap-To of any kind.

 

[CorBlimeyLimey]

Can you post a sample part?