Hole wizard fit call outs.

[tap90291]

I there any way to create a favorite drilled hole that will give me say an H7 tolerance with the drilled hole for a dowel pin. I have tried editing the 3d sketch dimension and adding the H7 or what ever and it works, I tried going in and editing the feature in the hole wizard, but it does not pick up the fit for future holes.

 

[SBaugh]

Sounds like you need to add a custom Database to use for any speical holes you want to make - See this link on how make a new Database -

http://www.scottjbaugh.com/Tips_Tricks/Data_Options.htm

- Remember though if you make new (customized) threaded holes you will need to add them to the Thread Data at the end of your new Database.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376