HOLES STANDARD 1

[JeniaL]

trying to create holes standard for rivets but can find nothing about that over the Internet.
created a folder in catia program files and copied standard from counterbored holes folder.
any ideas on how can this be edited?

std:node name="Metric-cap-screw" xmlns:std="

http://www.dsweb.com/std">

<std:node name="Units">
<std:node name="Angle">
<std:strval name="angle">deg</std:strval>
</std:node>
<std:node name="Diameter">
<std:strval name="Diameter">mm</std:strval>
</std:node>
</std:node>


<std:typedef name="CounterBoredHoleValues">
<std:strval name="Name">MS20426AD3</std:strval>
<std:floatval name="MainDiameter">2.5</std:floatval>
<std:floatval name="CounterSunkDiameter">4.65</std:floatval>
<std:floatval name="CountersunkAgle">100</std:floatval>
</std:typedef>

 

[JeniaL]

well i'm trying to change standard in admin mode but nothing happens.
i want to define angle and diameter. when i save standard and create a hole using this standard
catia is still locked on depth and angle mode however definition in standard is angle and diameter.

 

[DBezaire]

I dont have time to test it but grab the hole standard out of the attached PDF and see if that works for you. I dug this up off the Dassault support page while checking for service packs.

Regards,
Derek


Win 7
23SP5/24SP3, 3DVIA Composer 2015

 

[JeniaL]

Derek thank you so much for this attachment..works fine