Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Holes

Status
Not open for further replies.

Santa123

Mechanical
Oct 2, 2006
80
PL
Hello,

Do you use VBA to create holes?, what method do you use. Mostly I create holes in Plates, using rectangular pattern by means of PowerCopy and UDF.

Best Regards
Santa
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top