Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hollow Back vs. Solid Flange for DIP

Status
Not open for further replies.
jpandf

jpandf

Civil/Environmental
May 2, 2006
7
Is there any reason to be concerned with allowing fabricated DIP with hollow back flanges in a standard specification?
 
Status
Not open for further replies.

Similar threads

eddtan
  • Locked
  • Question
Suction pipe diameter vs lift height
Replies
9
Views
515
LittleInch
LittleInch
U
  • Question
GAC Backwash intervals
Replies
3
Views
3K
QualityTime
QualityTime
wright44
  • Locked
  • Question
Corrosion Control: Calcite for RO Permeate
Replies
9
Views
739
wright44
wright44
ChrisPeterson
  • Locked
  • Question
C-900 vs. Ductile Iron
Replies
9
Views
505
hydrae
hydrae
Hasibullah
  • Locked
  • Question
gpm sizing for WTP/WWTP Piping gallery
Replies
1
Views
480
bimr
bimr

Part and Inventory Search

Sponsor

Back
Top Bottom