I d like to hot tap (install two- 2 inch nozzels) a small tank that contains crude oil. This tank was designed under API 650. I was checking this standard, but since this code governs design, does not indicate me how to hot tap it. What standard can I look for guiding me thru ?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hot tapping in low pressure tank
- Thread starter Hierro
- Start date
athomas236
Mechanical
Hot tapping is just a construction/erection procedure, any nozzles installed on tanks have to comply with the relevant code in terms of design irrespective of construction/erection procedure
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question