RipV
Mechanical
- Jul 18, 2003
- 30
We are currently looking at upgrading to NEW systems. We run SW2007 now & have 2008 but have not installed yet. Here is what I have now:
(taken from control panel/system/general)
Dell Precision 650 series CPU
XP Pro Version 2002, Service Pack 2
Xeon CPU 2.80 GHz
2.79GHz, 1.00 GB of Ram
Video Card:
NVIDA Quadro4 900XGL, 128MB
What specs should we look for for a "very good" system. We don't want the minimium.
PROCESSOR TYPE, SIZE, RAM, VIDEO CARD & SIZE ETC, the whole 9 yds.
Our modeling many times consists of imported stp files, shaped parts, assemblies & subassemblies & we experience many delays & crashes. We also run MS Office products & JobBoss V8 as well.
Any input would be appreciated so we get good systems.
Thanks,
Ken
(taken from control panel/system/general)
Dell Precision 650 series CPU
XP Pro Version 2002, Service Pack 2
Xeon CPU 2.80 GHz
2.79GHz, 1.00 GB of Ram
Video Card:
NVIDA Quadro4 900XGL, 128MB
What specs should we look for for a "very good" system. We don't want the minimium.
PROCESSOR TYPE, SIZE, RAM, VIDEO CARD & SIZE ETC, the whole 9 yds.
Our modeling many times consists of imported stp files, shaped parts, assemblies & subassemblies & we experience many delays & crashes. We also run MS Office products & JobBoss V8 as well.
Any input would be appreciated so we get good systems.
Thanks,
Ken