How do I import a .prt file?

[Trent5791]

How do I import a .prt file?
Thank you!

Thank you,
Trent
NX 9.0.3.4

 

[cowski]

Open the file that you want to import to, then use File -> import -> part.

www.nxjournaling.com

 

[Toost]

It depends if the .prt is an NX part file or a PTC/ProE/Wildfire .prt.
NX: See Cowskis post above.
PTC... You will need to use the special translator under File- Import - Pro/E

If you don't know the originating system, I think you can open the file ( if it is relatively small , say <2 MB) in the Notepad
somewhere in the mass of unreadable garble it will print " Parametric Technology" or "Siemens".

( I did that a few years ago.)'

Regards,
Tomas

 

[Trent5791]

Thanks guys!

Thank you,
Trent
NX 9.0.3.4