Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I move a sketch that has been extruded in Solidworks 2010?

Status
Not open for further replies.

sabasab

Computer
Joined
Sep 26, 2010
Messages
4
Location
CA
Hi.
I have a solidworks 2010 file with a main body of a coffee press and the handle.

I need to move the handle so that it is in line with the rest of the coffee press body (Glass Caraf).

I also need to move anothe part, that looks like a screw bit, to inserct a cylinder so that I can do a Surface Cut.

The screwbit part only moves up and down, and not right to left, and ofcourse I need it to go left. However, I can't figure out how to move these parts.
 
Is this coffee press part of an Alaskan venture?
 
I don't see the body, only the handle. My program is asking for MasterForm.sldprt.
 
Sounds like something that happened to me. I had to change a boss that was extruded up to a point on a sketch. I had to add a new point to the sketch and make the sketch visible to change what the boss extruded to.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top