How do I wrap text around a sketch curve using NX 7.5?

[eneumann]

Referencing post: thread561-226111

Please see attachment. I am using NX 7.5 and want to wrap text around a curve on my detail drawing. This is for silk screening so I don't believe it is necessary nor do I want the text to show on the model. Does anyone have a solution?

Thanks,

eneumann

 

[jerry1423]

Insert -> Curve -> Text
Top pull-down menu change to On Curve
You will need a curve as a baseline for the text but you should be able to figure it out
Ask if you need more help

 

[eneumann]

Jerry,

Your solution seems to be in modeling rather than drafting. Do you know of a solution in the drafting role?

 

[jerry1423]

You are right it is for modeling, but you can also do it on the drawing
If you don't see the below pull-down menu then you may want to check your Roles
Insert -> Curves/Points -> Text

 

[JohnRBaker]

Sorry, there is no option in NX to align the letters of a single Drafting note in anything other then a linear scheme.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.