Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do you run a VBA application in Creo
- Thread starter aluminum2
- Start date
I do not know the answer, but some of your terminology leads me to think you have used NX in the past.
This would be possible in NX "customize the menuscript to run them as a pre or post action".
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
This would be possible in NX "customize the menuscript to run them as a pre or post action".
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
See the last response here:
Almost no one uses the VB-API for Creo as it is painful and essentially unsupported. CREOSON has a better chance; I have used AutoIt with a few mapkey helpers but many companies hate using other software and can fire people for doing so. I have also used Excel VBA to create mapkeys on the fly that I load and run.
Almost no one uses the VB-API for Creo as it is painful and essentially unsupported. CREOSON has a better chance; I have used AutoIt with a few mapkey helpers but many companies hate using other software and can fire people for doing so. I have also used Excel VBA to create mapkeys on the fly that I load and run.
- Status
Similar threads
- Locked
- Question