Hello Everyone!
I have been trying to develop a product which requires the assembly of a silicone slit valve in a plastic component.
I bought a product containing this assembly but I can't seem to figure out how it is done.
The picture below show what I am trying to achieve.
I am assuming that the same principal is applied to achieve the assembly in this picture:
Any advice would be helpful!
Thanks
Abhinav
I have been trying to develop a product which requires the assembly of a silicone slit valve in a plastic component.
I bought a product containing this assembly but I can't seem to figure out how it is done.
The picture below show what I am trying to achieve.
I am assuming that the same principal is applied to achieve the assembly in this picture:
Any advice would be helpful!
Thanks
Abhinav