jolielily
Electrical
- Oct 31, 2012
- 9
Hello,
I am new learner for E-TAP, when I do the single-line diagrams, for example, I drag the motor symbol from the toolbar, then it shows the motor is Mtr2, 0HP, my motor is 500 HP, how can I add this load -500 HP to the motor, I try to check the properties to change , but seems could not find any place to fill in 500 HP.
Does anyone who knows about it?
Thanks.
I am new learner for E-TAP, when I do the single-line diagrams, for example, I drag the motor symbol from the toolbar, then it shows the motor is Mtr2, 0HP, my motor is 500 HP, how can I add this load -500 HP to the motor, I try to check the properties to change , but seems could not find any place to fill in 500 HP.
Does anyone who knows about it?
Thanks.