Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to apply Accelerations?

Thread starter flyforever85
Start date Mar 9, 2021

Status: Not open for further replies.

Mar 9, 2021

flyforever85

New member

Hi,
never used accelerations before in Hypermesh. I have the full mode of an helicopter with some masses attached with RBEs. I want to apply ANGULAR accelerations to the CG and run an inertia relief analysis. Any way to do it? I also have the relative inertia factors (the "g"). Can't use GRAV card of course