how to call component in nx from teamcenter database by using journal

[lalit.patil]

hi,

i am trying to write journal for calling component from teamcenter databse at absolute, which path should i used for calling component as parameter

 

[cowski]

A good starting point is to record a short journal while performing the action that you want to automate. I've found that it helps to run through it once before recording the journal. It sounds like you want to add a component to an existing assembly. In that case, I'd open an assembly and add a component making sure to set up the desired options in the dialog. Now undo the action, start the journal recorder, and do it again. The dialog should keep your desired settings - this will help minimize unnecessary code in the resulting journal, making it easier to understand and pick out the important bits.

www.nxjournaling.com