Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to change stress points in the cross section of beams in sap2000

Thread starter Roberto Llerena
Start date Feb 14, 2020

Status: Not open for further replies.

Feb 14, 2020

Roberto Llerena

Civil/Environmental

Hi!!
I need help
I wanna know how to change the stress points in the cross section in beams in sap2000 v20.
The software by default define points in the cross section and gives the stresses calculates in this points, but i need find the stresses in other points that are not defined, how can i change this points or aggregate other differents in the cross section.