Parham.13.20
Structural
- May 30, 2024
- 1
Hello all.
I have modeled and partitioned an I-beam in Abaqus. I want to apply a triangular line load along the centerline of the I-beam's web (red Line in picture). However, when I try to select the centerline, it's not selectable. How can I accomplish this?
Please note that I do not want to create the I-beam using the 'Wire' sketching tool and then assign an I-shaped section to it.
I have modeled and partitioned an I-beam in Abaqus. I want to apply a triangular line load along the centerline of the I-beam's web (red Line in picture). However, when I try to select the centerline, it's not selectable. How can I accomplish this?
Please note that I do not want to create the I-beam using the 'Wire' sketching tool and then assign an I-shaped section to it.
