How to create Macros in Machinning

[Antseg]

Hi everyone !

I would like to know if anyone has any idea about macros in machinning workbench. I have read How to create Macros by Emmet Rose but there isnt any chapter about manufacturing or machining workbench. And using record macro i cant figure out too much.

Thanks

Antonio

 

[itsmyjob]

check coe.org forum... manufacturing section is very active with plenty of code

Eric N.
indocti discant et ament meminisse periti ​

 

[Antseg]

Thanks . I will check that forum