Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to create Rigid links using Center of gravity and Moments of Interia in Ansys WB?

Thread starter Bruce321
Start date Jan 1, 2015

Status: Not open for further replies.

Jan 1, 2015

Bruce321

Mechanical

Hello,
I need to analyse Rigid Body dynamics using a cross of two Rigid links attached to flexible D shaped 2d sketch in Ansys Workbench. The dimensions which I have are just centre of gravity of these two rigid links and Principal moment of Inertia. [ponder]