Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to delete a partition during a job.

Thread starter pitagoras15
Start date Oct 20, 2014

Status: Not open for further replies.

Oct 20, 2014

pitagoras15

Industrial

Hi,

I need to make some simulations of a wall drilled in 2D on Abaqus. I need to know if is there any possibility to apply heat flux, and then eliminate a partition, all in the same job. I've been looking in the 'Steps' but I don't find the way.

Thanks in advance.

Regards.