Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

How to draw split lines in 2D axisymmetric nonlinear simulation

Status
Not open for further replies.
Jorgenf

Jorgenf

Mechanical
Feb 13, 2018
8
0
0
NO
Can anyone tell me how i can draw split lines in an 2D axisymmetric nonlinear simulation. I want to do this in order to use the mesh control function on them, to increase the nodes in the critical areas, and reduce run time. I am using SW 2016.
 
Status
Not open for further replies.

Similar threads

IdanPV
  • Locked
  • Question
Apply Moments in Solidworks Simulation
Replies
2
Views
28
IdanPV
IdanPV
Joel_Lapointe
  • Locked
  • Question
Cylindrical coordinate system shear stresses for SolidWorks Simulation?
Replies
0
Views
24
Joel_Lapointe
Joel_Lapointe
lpresciuttini
  • Locked
  • Question
Pressure Vessel Linearization (Simulation): Invalid points
Replies
1
Views
24
IdanPV
IdanPV
Joel_Lapointe
  • Locked
  • Question
Impose mesh coordinates multiple different simulations (SolidWorks Simulation)
Replies
2
Views
30
Joel_Lapointe
Joel_Lapointe
cobra46
  • Locked
  • Question
how to include damping in a shock study
Replies
5
Views
13
statist1
statist1
Back
Top