Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to extract complete stiffness matrix from SAP2000 model for a truss structure?

Status
Not open for further replies.

Abdur_Rasheed

Structural
Jan 29, 2018
4
Dear all,
I have to extract the stiffness matrix of a 2D truss structure and i followed the correct procedure of extracting K values but the software gives half of the K matrix values. My question is whether the software just gives the half of symmetric stiffness matrix or we can get the complete stiffness matrix as well?
Thanks!
 
Replies continue below

Recommended for you

Do a simple structure (like 2 nodes) and compare the output to a hand check of the assembled stiffness matrix? If its giving one half (above or below the diagonal) of the full matrix, I guess you need to confirm what half (top/bottom) obviously and the format so you can reassemble the entire thing.

I've never extracted the stiffness matrix, but it would seem like it would be something that is bound to be documented in the manuals? If not a quick email to CSI might provide an definitive answer.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor