How to make a sketch show in a detail drawing?

[bry593]

I'd like to show a sketch used to create a round protrusion cut as a centerline on the detail drawing. The centerline is needed to convey what the shown sketch dimensions are dimensioning.

In some 3D software, this is a simple "project" command, but I cannot find a similar command anywhere in WF2. I've tried the "Help" menu, but after perusing many returns, still no answer...

 

[bry593]

Nevermind, got it. Just turn the curves layer on, then use Sketch > Edge > Use. Then right click all the new sketch entities and change linestyle to centerline.