deb123podder
Structural
Dear all,
on creating a 1-D table with TEMPERATURE as VAR1 and HF (or CONVECTION FILM COEFFICIENT) as VAR2. I then edit the Table and input the temperature and film coefficient required.
On applying the convection on the required areas of my model and after putting the heat flux on a specified zone when i'm going to solve the current load step, ANSYS produces an error, stating 'missing parameter = HF' . Can anybody help in this regard ??
Thanks-
Debabrata.
on creating a 1-D table with TEMPERATURE as VAR1 and HF (or CONVECTION FILM COEFFICIENT) as VAR2. I then edit the Table and input the temperature and film coefficient required.
On applying the convection on the required areas of my model and after putting the heat flux on a specified zone when i'm going to solve the current load step, ANSYS produces an error, stating 'missing parameter = HF' . Can anybody help in this regard ??
Thanks-
Debabrata.