how to set contact angle and surface tension in ansys CFX V11

[vinny31]

Hi
I am using ansys cfx v11, i am a very recent user to this program so i am still learning.
I am trying to set the contact angle and surface tension of water in a simple transient fluid analysis.
However i cannot see how to set these parameters. Can anyone advise me on how to do this or even have and example

regards

V

 

[smo12345]

I don't know your answer, but I would suggest posting your question at

http://www.cfd-online.com/Forum/cfx.cgi

if you have not already. This forum is for CFX users. You may get a reply sooner.