NIYAZJAMAL
Structural
- Sep 4, 2012
- 7
- 0
- 0
how to show the dimensions of the structure in sap 2000?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to show the dimensions of the
- Thread starter NIYAZJAMAL
- Start date
- Status
NIYA, I don't think there's a way to display dimensions. Hello, CSI! Please add this capability to SAP. Even ETABS' klutzy dimensioning would be welcome. You might try exporting your model to DXF to view dimensions, but that would be extra effort.
You can draw a "None" null frame element with snap to joint activated in order to view distances between any two point, but again, that's a little lame. A "distance calculator" tool between two points is needed.
You can draw a "None" null frame element with snap to joint activated in order to view distances between any two point, but again, that's a little lame. A "distance calculator" tool between two points is needed.
johnbridge231
Civil/Environmental
yes, this feature is not supported. Unfortunately..
Analysis and Design of arbitrary cross sections
Reinforcement design to all major codes
Moment Curvature analysis
Analysis and Design of arbitrary cross sections
Reinforcement design to all major codes
Moment Curvature analysis
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question
- Locked
- Question