Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to simulate diferent CAD geometries with same settings/parameters in ANSYS Fluent

Status
Not open for further replies.

andradesilva

Materials
Jun 20, 2017
125
Hi all,

I am getting started with ANSYS Fluent in my new job. I have a large number of CAD geometries that I build and I have run simulations in ANSYS Fluent using them. My simulations are all the same in terms of settings, just the CAD geometry is different. My question is: How can I save the settings/parameters of a simulation, so I can simulate different CAD geometries without having to define all the settings/parameters all over again in each one?

I thank you in advance,

Best regards,
Hugo


 
Replies continue below

Recommended for you

have you tried scripting (File > Scripting>Record Journal) at ANSYS?
you can click on Record Journal at the beginning, before you start defining and entering the parameters.
then you will get a file with XML language.
for the next task you can call the file "Run Scripting file" again.


this code from Github can also be helpful.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor