How to smooth two connected surfaces?

[Sacaq]

Hi~
I created two connected surfaces and performed a porcupine curvature analysis.
However, I found the curvature is not continuous as attached file.
Can you tell me how to smooth the connection and thus the curvature?
Thank you.

 

[rstupplebeen]

Improving the geometry will be dependent on how you created it. Can you post the model or a simplified model? This could include just the couple of surfaces in question or a dummy representative model.

Rob Stupplebeen

http://www.optimaldevice.com

https://sites.google.com/site/robertkstupplebeen/

 

[sudhakarn]

Hi,
you need to match the radius of curvature at the joining point for the two surfaces to get the curvature continuity.For example if the radius of the curve1 (surface1)at the junction is 20mm,then the radius of the curve 2 (surface2) at the junction should be 20mm.
Radius = 1/Curvature.

Hope it helps.

 

[Sacaq]

Thank you all~
Here is the file.
However, I still don't know which function I should use and how to modify the surface.
Thanks for your help!

 

[rstupplebeen]

I checked out the surfacic curvature and it looks good. I did see what you had for the porcupine analysis. If you need more help provide the parents of the geometry in question as dumb surfaces but create this surface in the representative model. That way we can modify it and you retain the IP. I hope this helps.
Rob

Rob Stupplebeen

http://www.optimaldevice.com

https://sites.google.com/site/robertkstupplebeen/

 

[itsmyjob]

Hello,

I guess I am not the only to think your surface is OK. The curve is not.

I was able to create a spline on the surface with no curvature problem.
Also Cutting Plane Analysis function shows clean section (FSS license)

Create a new curve with 'geometry on surface' option turn on

Eric N.
indocti discant et ament meminisse periti ​

 

[Sacaq]

Thank you all~
Sorry that I don't have the parent file of the geometry.
I am confused with the zigzag-ed porcupine analysis on the connection of the surfaces.
The Surface Curvature Analysis is smooth, but the Porcupine Curvature Analysis of the curve across the edge connection is not, as attached in the first post.
If the reason of zigzag is not from the non-smooth connection of the faces, why it happens and how to handle with this?
Thanks for your help!

 

[itsmyjob]

How did yuo create that curve?

Eric N.
indocti discant et ament meminisse periti ​

 

[Sacaq]

The curves comes with the file. I didn't create it.

Yesterday, I made a porcupine curvature analysis on the original white curve.
Then, I created another curve on the surface and a porcupine curvature analysis on this curve.
The 2D diagram of the porcupine curvature analysis of the new curve is strange, as attached file.
The discontinuity of the porcupine curvature analysis was not found on the intersection of the new curve and the center curve of the surface, maybe it's unclear ,but was found on the intersection of the new curve and the upper curve of the curve.