Apr 20, 2009 #1 NCSU1980 Mechanical Jan 29, 2008 16 0 0 How can I stack dual dimensions. They take up too much room located side by side. SW 2006 sp 5.0
Apr 20, 2009 #2 handleman Automotive Jan 7, 2005 3,411 0 0 US Tools->Options->Document Properties tab, Dimensions category, -handleman, CSWP (The new, easy test) Upvote 0 Downvote
Apr 20, 2009 Thread starter #3 NCSU1980 Mechanical Jan 29, 2008 16 0 0 I went to Tools->Options->Document Properties tab, Dimensions category, but cannot find choice needed. Upvote 0 Downvote
I went to Tools->Options->Document Properties tab, Dimensions category, but cannot find choice needed.
Apr 20, 2009 #4 handleman Automotive Jan 7, 2005 3,411 0 0 US Sorry, guess it's moved around since '06. It should be in there somewhere.... -handleman, CSWP (The new, easy test) Upvote 0 Downvote
Sorry, guess it's moved around since '06. It should be in there somewhere.... -handleman, CSWP (The new, easy test)
Apr 21, 2009 #5 rhbalance Mechanical Apr 21, 2009 6 0 0 US options->document properties->dimensions under dual dimensions check top/bottom/right/left Upvote 0 Downvote
