how to tell the parison to stop inflating upon contacting the mould in ANSYS Polyflow blow-moulding

[andradesilva]

Hi,

I am running a blow-moulding simulation in ANSYS workbench via the Polyflow module. I am inflating a bottle. I can solve the model and obtain results. However, the parison should stop inflating the contacting zones when it contacts the bottle (mould). How can I setup the simulation in a way that the parison stops inflating upon contact with the mould? I currently have the parison inflating a lot past the geometric limits of the bottle.


Thanks in advance,
Best regards,