Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to use APDL to create probes?

Thread starter marlonsaveri
Start date Oct 9, 2015

Status: Not open for further replies.

Oct 9, 2015

marlonsaveri

Mechanical

Hi,

I would like to automate the creation of probes in Workbench Mechanical Results. I.e., I would like to use a APDL (or Matlab) command to create a lot of probes and export a table relating X, Y and Z deformations at these points, considering a Coordinate System I created. Is it possible? How?