Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HP-gl plotting

Status
Not open for further replies.
RicG

RicG

Mechanical
May 25, 2001
3
I am trying to plot hp-gl file using solaris to a large format printer with roll feed capability. When I send the file it trims off after about 50". When I add the FR command and resend the data within the plotfile I get the whole plot but then get about 45" of blank paper at the end. This plot is about 55" , but I will be making plots from 24" to 140" long.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I have worked out the problem, No input needed thanks anyway
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom