Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

http://www.eng-tips.com/viewthread.cfm?qid=339995

Status
Not open for further replies.
nhernandez

nhernandez

Mechanical
May 19, 2016
2
thread1183-339995

Please refer to the above thread...I am still confused on how to set a virtual plane with an angle of inclination to yield correct results. I keep getting a results that appears the plate will deform but parallel to the face not to the virtual wall.

Any thought would be much appreciated. Thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom