HydroCad exfiltration volume

[TheEnginerd]

Using HydroCAD to prepare calculations to meet NJ state groundwater recharge requirements (infiltration of the increase in 2 year storm runoff volumes).
After applying the design infiltration/conductivity rates, where can i view how much total water has been infiltrated? The summaries indicate a volume in cubic feet of discarded flow (infiltration), however that particular calculation stops at 14 hours and therefore increasing height of my orifice isn't generating an increase in infiltrated volume because i think this occurs after the 14 hour mark. My calculations are set to go through 36 hours, so i'm not sure why i can't see a total infiltrated volume for the entire storm.

Thanks in advance.

 

[TheEnginerd]

FIGURED it out, sorry - silly mistake on my part

 

[psmart]

For the benefit of others who may be interested: The answer is to increase the calculation time span.

Peter Smart
HydroCAD Software

http://www.hydrocad.net