Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hydrogren Peroxide level to sanitize DI piping?

Status
Not open for further replies.

Trogdor

Mechanical
Aug 19, 2003
4
Anyone know what ppm level is a good place to start when sanitizing a DI recirculating system? I have watched our DI service do the sanitization process many times, but I don't know the level of hydrogren peroxide necessary.

Thanks.
 
Replies continue below

Recommended for you

It varies from 3 to 10% depending upon the system condition and duration between two sanitization cycles. Just take care to keep the fluid temperature below 25C as H2O2 is highly unstable beyond this temperature. Make sure that post washing traces are less than 1ppm.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor