Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I am doing a freq-voltage conversio

Thread starter 01795584233
Start date Nov 5, 2002

Status: Not open for further replies.

Nov 5, 2002

01795584233

Automotive

I am doing a freq-voltage conversion. But need to design a feedback element in the design loop(f/v converter)to control the frequency. Do u have any suggestion about that?. Is there any realisation software to check a digital output(after converting 0-10v to required digital signal through DAC).

Thanks
Senthil