Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I am trying to get dimensions to render in autodesk inventor 10.

Thread starter ffiarpg
Start date Jun 7, 2006

Status: Not open for further replies.

Jun 7, 2006

ffiarpg

Mechanical

I have an assembly in inventor and I cannot get the dimensions to carry over into the rendered video. The dimensions show up fine in the assembly and when the video is played without rendering, but I need them to carry over to the rendered video so i can upload it. Thank you for your time.