I cannot activate the transformatio

[D Johnson]

I cannot activate the transformation icon on my Catia V5 R20. I went to tool and selected Customize,Toolbars and selected restore all contents, ok and then restore position ,ok and close. This did not solve the issue?
It will activate when I'm in the customize window only but once I close it the icon deactivates. i'm run Catia on a Pro Mac Book with an intel processor through bootcamp.

 

[Wuzhee]

Are you in the correct workbench?

 

[D Johnson]

yes in Part design window?

 

[rickyt]

No content in active body it will be deactivated.

↓No Content in Active Body↓

↓Content in Active Body↓

↓No Content in Active Body, but content in a different Body↓

 

[D Johnson]

the body is Active. There is a glitch that will not let me activate the transformation icon in the Part design workbench?
also is there a lates version that I can purchase. like V5 or V6 R29?

 

[Wuzhee]

Maybe you should reset your catia settings and start over. But make a backup beforehand.

Contact dassault or a retail on prices. This software is very expensive (around 7-11k € a year, depending on licenses) I think the latest is Catia V5R33(2023).

 

[NP_1612]

V5-6 R2024 is the latest current version. There are no 'Rnn' versions officially - these are fabricated version terms following older release naming.