I need to combine two sketches to produce my component.

[barnsey1]

Hi All,

I am new To NX so there could be a relatively easy solution to this, but I am struggling to Sweep the two profiles shown in the attachment,
Has anyone any advice how I could produce the two combined sketches.

I am currently using NX 6.0

Thanks in advance.

 

[JohnRBaker]

I assume that this is what you're looking for (see attached Part file). The operation that you were looking for, after creating the two solid bodies from the Sketches, can be found at...

Insert -> Combine Bodies -> Intersect...

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[barnsey1]

Thanks for your help John,

Big help that!