I posted this thread on Mechanical Engineering - generic - should probably be here

[oharag11]

I don't know how to move. Can you read this thread and comment:

Detail View - solid line vs phantom? What is standard? - Mechanical engineering general discussion

So, I just started using CREO and used the detail view callout tool. I was surprised that the circle drawn was solid. I asked a colleague, but we couldn't figure out how to change this. So, I went to SolidWorks to give it a go. No, SW is solid as well. You can change the line style - though it...

www.eng-tips.com

Thanks

 

[Garland23]

It looks like the pertinent standard would be ASME Y14.2 (link below; scroll toward the middle of that page). I don't have a copy in front of me, but it should be mentioned in that one or maybe Y14.3.

https://www.asme.org/codes-standards/y14-standards