Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Identify the changes

Status
Not open for further replies.
robcp

robcp

Automotive
Jul 28, 2004
41
0
0
CA
What is the best way to determine the changes between two different engineering levels of the same component. Is any special method of overlaying the two parts and identify automatically the changes?
Thank you.

Rob
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Hi,

If you have DMU space analysis lic. you can use the Copare Products command to compare visually between 2 different levels. gives a good result.

Amit
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

sri91
  • Locked
  • Question
identify part or product document
Replies
2
Views
18
sri91
sri91
Bombas
  • Locked
  • Question
msgcatalog - name changes of front view e.t.c.
Replies
2
Views
18
Bombas
Bombas
c800
  • Locked
  • Question
Need the code to get access to the properties and isolate the parts and save it 1
Replies
3
Views
28
Little Cthulhu
Little Cthulhu
Mirme.lee
  • Locked
  • Question
How to activate the sheet to which the selected view belongs?
Replies
3
Views
25
Mirme.lee
Mirme.lee
Hix066
  • Locked
  • Question
Modify the default CATPart / CATProduct?
Replies
1
Views
26
Little Cthulhu
Little Cthulhu
Back
Top