Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Idiots guide to riveting

Status
Not open for further replies.

KENAT

Mechanical
Jun 12, 2006
18,387
Other than the obvious Machineries Handbook, anyone know of any good online guides to riveting?

An intern I'm not supervising is looking at riveting some clips to a 'base board' type part. Similar to what you see on the bottom of fridges etc.

I'm looking to give him some information, sadly his supervisor is electrical and I don't have time to help (plus my help may not be appreciated) and I've forgotten much of what little I used to know. (And I don't have the rivet catalogues anymore.)

I found the link immediately below and the you tube was posted a while back.



Thanks for any suggestions.


KENAT, probably the least qualified checker you'll ever meet...
 
Replies continue below

Recommended for you

Pages 3213, 3217 (etc) have similar info.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of Eng-Tips Forums?
 
Thanks to both of you.

KENAT, probably the least qualified checker you'll ever meet...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor