Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ignore collisions in a simulation

Thread starter adicm
Start date Jan 11, 2005

Status: Not open for further replies.

Jan 11, 2005

adicm

Mechanical

Is there a way to ignore collisions in a simulation? I want to see the movement in an assembly that have a lot of interfering parts (it was imported from other CAD, and it is so hard to try to fix it). I only need to see the motion along the full path and the simulation always stop at the first collision...

Adi Corrales Magallanes
Centro de Ingenieria y Desarrollo Industrial
Queretaro, Mexico