Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

IGS File

Status
Not open for further replies.
Kae

Kae

Mechanical
May 3, 2000
16
Is it possible for CATIA to open IGS file
in Solid Modeling? If possible, how?

Many thanks in advance!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Yes, you have to use IGECAT utility but you will not get solids only a volume (if your lucky) or at best faces and surfaces only

regards Mick
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question
Frame/Titleblock Macro - call image file in same parent folder 1
Replies
6
Views
1K
Little Cthulhu
Little Cthulhu
wchasemason
  • Locked
  • Question
Automating the exporting of mesh data from an Analysis file using VBA
Replies
1
Views
319
Little Cthulhu
Little Cthulhu
Nagaraj Metri
  • Locked
  • Question
CATIA V5 MACRO: Insert a table from existing CATDrawing file
Replies
2
Views
333
Nagaraj Metri
Nagaraj Metri
nainh
  • Locked
  • Question
Problem when importing STEP file into CATIA - Assembly combined into one PART & PARTBODY
Replies
3
Views
1K
MarcL68
MarcL68
Sidtha
  • Question
How to loop through already opened .CATDrawing files in catia v5 using vba
Replies
3
Views
3K
Little Cthulhu
Little Cthulhu

Part and Inventory Search

Sponsor

Back
Top Bottom