Import a part with a Product Template Studio definition

[PSI-CAD]

Hi,

I tried to import a part with a PTS definition but the result doesn't contain the PTS.

Is'it possible by another way ?

Thanks in advance

Regards
Didier Psaltopoulos

http://www.psi-cad.fr

 

[PSI-CAD]

Hi,

Nobody have the answer ?

Regards
Didier Psaltopoulos

http://www.psi-cad.fr

 

[TaylorAnderson]

Didier --

Sorry for the delay... Haven't been on this board for a while.

There's not a way to transfer a Product Template Interface from one part to another right now... the challenge is properly re-parenting all of the UI elements to the new expressions and features of the destination part.

Could you possibly go the other direction? Use the Reuse Library to copy/instantiate the Product Template, and then import the other content into the new Product Template?

Taylor Anderson
NX Product Manager, Knowledge Reuse and NX Design
Product Engineering Software
Siemens Product Lifecycle Management Software Inc.
(Phoenix, Arizona)

 

[PSI-CAD]

Hi Taylor,
Thanks for your answer, I will try tomorrow

Another subject: could you send me an example with PTS and part family ?

Thanks in advance

Regards
Didier Psaltopoulos

http://www.psi-cad.fr

 

[TaylorAnderson]

At the moment I'm getting ready for PLM Connections next week, but give me some time...

Taylor Anderson
NX Product Manager, Knowledge Reuse and NX Design
Product Engineering Software
Siemens Product Lifecycle Management Software Inc.
(Phoenix, Arizona)

 

[PSI-CAD]

Hi Taylor,
Thanks, I will be patient

Regards
Didier Psaltopoulos

http://www.psi-cad.fr