Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

import geometry from Ansys Classic to Ansys Workbench?

Status
Not open for further replies.

adilch

Civil/Environmental
Apr 17, 2012
11
DE
Is there any way to import geometry from Ansys classic to Ansys Workbench? Actually I have APDL for modelling in Ansys Classic. How I can do it?
 
Replies continue below

Recommended for you

I'm slightly confused by your question. If you can import your geometry into ANSYS classic then I would guess its highly likely you can import this into workbench. What is the format of your geometry?


------------
See faq569-1083 for details on how to make best use of Eng-Tips.com
 
Hi, thanks for reply. Actually I have modeled a pressure hose in Ansys Classic by APDL commands. I want to get that model in Workbench also. How i Can do it?
 
Not sure it's possible. The other way round is more common (workbench to ANSYS).

You may be able to link your results file in ANSYS to an object within workbench, and therefore you'll need to solve the model again, but I've never tried this.


------------
See faq569-1083 for details on how to make best use of Eng-Tips.com
 
You should write your file as CDB format in Prep7-Archive model-write. then use the FE Modeller to read in CDB files.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top