Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Import MathCad 3d plot to SW

Thread starter Aedifex
Start date Jun 11, 2011

Status: Not open for further replies.

Jun 11, 2011

Aedifex

Structural

I found this passage on a discussion thread from 2005 (

http://www.eng-tips.com/viewthread.cfm?qid=123400&page=420

) in this forum:

"3D plots/graphs turned directly in to a solid model for prototyping. A great addition to SW."

Does anyone know if this is somehow possible?

It would be very useful for me, but I can't find any other mention of this function, and I can't figure out how to do it.

Yours
Ae