Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

importing a scanned jpeg 1

Status
Not open for further replies.

ProEDesigner00

Mechanical
Oct 17, 2003
203
Hi everyone.

I have not had the experience to import a jpeg onto a surface for some creative work. I was fooling with Pro/E WF4 and see that you can save a jpeg into some other proe formates but did not get a clue on how to apply thee to a surface. Any information would be apreciated.

TIA

Norb

Norbert
 
Replies continue below

Recommended for you

You have to go into Color & Appearance editor and in the map tab add your jpeg as a decal. Then apply this "material" to your surface(s). There are many options as far as how you map the jpeg, single, multiple, rotation, etc.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor